oulton Park video

[JeffC]

NSCC should refund or carry over your race entry fee though If yes, then you might as well keep your fingers crossed, if not    

dunno havent had anything from them yet        

I want to be there on Saturday regardless suppose I cut two holes out the floor and use my feet to get round        

[Pilot Pete]

NSCC should refund or carry over your race entry fee though If yes, then you might as well keep your fingers crossed, if not    

dunno havent had anything from them yet        

I want to be there on Saturday regardless suppose I cut two holes out the floor and use my feet to get round        

Could stick that spare pinto in the meg and race that?

I wonder if you could have entered the meg if it was alive. Sure it would just need your extinguisher and it'd be reet, or does it have to have an MSA log book thingy?

[conibear]

email them and let them know your predicement.

My club will always carry over an entry fee till next month. But, other events or non member clubs normally as a rule of thumb give you upto three days before the event to pull out

[cast iron]

Being a 1540 busa Im guessing it wont be a custom piston. I'm going to take a wild guess that the original builder has picked the nearest standard piston, probably from a lower reving car, its probably too heavy for the revs and hence the cracking from the momentum at the top and bottom of the stroke. Can the rods be checked for any signs of elongation?

[JeffC]

no they are wiseco pistons made for the job and Ive been informed that each  block is bored/plated to the pistons , standard pistons/bore is 81mm and mine has 83mm , most of the extra cc comes from the stroker crank    

[JeffC]

have I run a black cat over or something      

place pistons are coming from forgot to send them out so engine hasnt been built today, If I make it on Saturday it will be a miracle at this rate      

[JeffC]

well I got home with engine last night at 11.00 so if things go my way It should be fitted this morning and run in this afternoon , collected the new manifold yesterday on the way down , looks good but Im not confident its going to fit  

[Terry Everall]

Good luck Jeff

[Asterix]

fingers crossed here Jeff - go for it

[slippy]

Good luck Coop

[Matt Seabrook]

You can do it Jeff

[Buzz Billsberry]

Jeeez jeff nowt like living on the edge. undies on the outside, hair gelled back and cape attached I hope you get it sorted

Buzz

[JeffC]

well it starts    

hopefully get it run in this after    

[Pilot Pete]

well it starts    

hopefully get it run in this after    

We'll no doubt be seeing you buzzing about!

[Black Busa]

Jeff,

Have you got a time table for saturday/sunday?

Thanks