Leaderboard

The gearbox had faired slightly better, and despite looking like it had spent some time sat outside or in a damp barn, the damage initially appeared limited to an inspection cover which had rusted in a hole but the inside still had a good layer of oil protecting everything and gear selection felt smooth. As I intend to build this car to be raced, the gearbox was duly despatched for a thorough inspection and rebuild to ensure all was working and in good order. As I worked to finish JW4 which I'm pleased to say is now complete and soon to be on its way to join the home of two of its sister cars in Belgium I only had time for a few small jobs on the Costin Walker, which mainly involved sourcing a few much need parts for the rebuild and for now that almost brings us up to date. Realising that the engine was not in a salvageable state I made the decision to strip it for all the parts that were unique to its install in the Costin chassis and then to seek out a replacement. The Costin runs the engine in a near vertical orientation at an angle of approximately 20degrees whereas in the Imp its laid near to flat, this means that all the inlet manifold, exhaust and also the cooling set-up are unique and needed to be swapped over. An adaptor flange is also mounted between the engine and gearbox to accommodate the different orientation of the engine but also because the box is run inverted in the Costin.

Tour of the Cambrian Mountains 2019

If anyone can remember MattyCatty from Yorkshire with the white supercharged S2000, he had the same problem as @LukeW and he broke down on the A1. That incident caused us the check our car's bolts and guess what? they were loose too. We had only just bought the car and never considered checking them. They were tightened up, using loctite and upon checking at a later date they had come loose again. This time the bolts were really, super cleaned before adding loctite and tightening, so far they have stayed in position, but they do get checked. The marking with Tippex/paint is a good idea so we have just done that, good idea @IanK (Bagpuss)

I like to start my build threads with a little bit of background and history and although this cars history started all the way back in 1968 my knowledge and involvement with it began much later than that. Those of you that have seen my other posts and build thread will know that my involvement in single seaters and specifically Johnny Walker's F4 cars began in around 2014 when I bought my first JW4 Formula four car, one of the first 1966 250cc Mk2 chassis. Walker only made 56 cars of which only 12 were Mk2's and search to find original parts to rebuild my particular car lead me on an unexpected journey which culminated in me obtaining much of the original factory records, drawings and tooling for the JW4. One car that had always intrigued me during my research was the very last car that Johnny Walker made; the Costin Walker. This car was something quite different to any of his previous F4 chassis and for which Walker had employed the talent's of Aerodynamist Frank Costin to design the chassis and bodywork who was famed for his early work with Lotus cars then later Marcos. More used to working with a wooden monocoque for his chassis construction on previous projects, for this commission his 18th car Frank Costin chose to adopt a space-frame construction and in his words to "carry it to its logical ultimate". Costin set out to design what was to become one of the stiffest space-frames ever produced for its weight and this very car went on to be displayed at the 1969 Racing Car Show at Olympia. I will continue the full history in later posts but, the history of the prototype was short lived when in 1971 during an F4 race at Lydden, the car spun striking the bank which caused damage to the front suspension upright and steering rack. Rather than rebuilding the car a disillusioned and financially strained Walker sought to sell the car, but it was not to be run again by any of the subsequent owners. The last recorded information I had of the car was a magazine cutting from 1991 where then then owner of the remains was seeking information about it's past. This article was the first breadcrumb in my search to find the whereabouts of the car as I wanted to learn of it's fate. As luck would have it the owners name in the article was quite unusual and after a session of googling I was able to find somebody with the same name but promisingly working in the motorsports industry. An enquiring email was sent and luck was again on my side as I had not only found the right person but also they were still the owner of the car having by then had it for nearly 40 years. I would add that at this time I had no intent in buying the car as my interest was in the researching the history of the marque. I arranged to meet the owner Denis and I was grateful that he was also willing to show me the car and fill in a few blanks about its history and whereabouts over the preceding years. Denis had bought the car in 1976, 5 years after its Lydden accident. back then it was in a sorry state having languished in a damp and draughty barn for 5 years and it's original 85bhp imp engine and jack knight gearbox had long since gone. After a period of storage Denis had set out to restore the car and at the time I first saw it in 2016 the car was still in pieces and the only part which had then been restored was painting of the chassis. A pleasant afternoon was spent kicking tyres and talking cars then I went on my way back home. A few more emails were exchanged between us over the next few weeks as I found out more about the cars history and we shared information and then that was it.

Driving to Sunk Island.

Out of the blue I received an email from Denis at the start of this year explaining that he was thinking of selling. I wasn't looking for another project as by now I was mid-way through the restoration of my third JW4 but this car meant something to me and these opportunities don't come along everyday. I'm not sure my partner Dawn entirely understands my passion about old cars or why I would pay quite what it did for a pile of dusty rotten old car parts designed by some slightly famous bloke but I nevertheless did. Given the relatively short timeframe in which I bought the car and the fact I was financially crippled in buying it at a time when I was already haemorrhaging money on finishing the restoration of my JW4 together with attempting a garden room build for the house, there was no spare cash or time to make a start. So nothing more was done other than sorting, labelling and boxing up in readiness for the re-build to begin. The car came with an engine, but this also had been stripped into parts so when the time allowed this would be my first challenge to see what was salvageable. It didn't take long for me to find that the years hadn't been kind to this, and with the head split from the block, moisture had been allowed to get into the bores and the crank was locked solid with the pistons rusted in place. The head wasn't looking much better either with rust on the camshaft and many of the lobes stuck fast. The carburettor is beyond rebuild.

September 21st, 2019 Spend: £0.00 I'd never been to the Peak District, so when I asked on the forums if my planned route for today was ambitious or not, @IanK (Bagpuss) kindly volunteered to show me around. What a day it was... We started out as four with @LukeW and @Nemesis joining @IanK (Bagpuss) and my son in his Mini Cooper S in Ashbourne. Afer some driving we met up with @Paul Hurdsfield, @bioman and Kibriyah (NWKCOG) at The Devils A***. More driving was done and my son and I arrived home 12 hours later than we left, with near enough 300 miles more on the clock. The full story can be read here. Last month: £ 9402.26 This month: £ 0.00 ----------+ Total: £ 9402.26

Westfield XI 2018 This Westfield XI is only for sale due to a complete change of direction and unforeseen change in circumstances. It is a new car which was IVA’d in NOV 2017 and then registered in Feb 2018. This is a special commemorative edition car 48 of 50. It has done 200 miles since the build. The body is the standard Westfield body kit, with Le Mans driver's head fairing, in Westfield racing green, with crimson carpets, dash and seats. The bodywork has been professionally machine polished. The dashboard is populated by a matched set of MG Midget instruments, all professionally rechromed, comprising fuel gauge, combined oil pressure/water temperature gauge, rev. counter, and speedometer fitted (and calibrated). The car has a factory optional tonneau cover supplied. All donor vehicle parts were fully reconditioned using MG specialist, the engine capacity was increased to 1330cc to give a better performance and converted to unleaded fuel. Twin SU carburettors, set-up by a period specialist (Ron Harper) to give excellent starting and running. Minilite wheels, Mountney period Red leather steering wheel, front anti roll bar, Tonneau cover. Front driver seat is on sliders. Asking price is £ 17,950 or near offers. Would also take a standard Westfield in part Exchange. For more details / pictures give me a call 07770 934673 or PM on here.

As mentioned earlier, at this stage I'm just sourcing parts and doing a small amount of trial assembly to check the fit of parts and ease of assembly, although I have some photos and a few of the factory drawings for this car, being a prototype I have a lot less detail and info compared to the JW4's that I'd built before. One problem I needed to resolve was the uprights both front and rear. During its development the car ran with two different types of front uprights. Initially Costin at the request of Johnny Walker design the car to use the JW4 magnesium uprights and front drum brakes, which were paired with 10" front wheels. Frank Costin had commented that these weren't perfect but initially worked ok, later on in the development the car was passed to Tony Hilder of Piper Cars to try and tame the handling and he adopted 13" front wheels in lieu of the 10's fitted by Costin and also fitted front disc brakes. When the car suffered its accident at Lydden in 1971 the Hilder front upright was broken beyond repair. Unbelievably I still have that damage upright amongst the boxes of parts. Not being able to source an identical replacement I was left with the option of either reverting back to the JW4 upright with drum brakes or sourcing a suitable alternative. Frank Costin in his design for the chassis had considered several different race series including F4, F3, F5000 and Formula Ford and designed the chassis to be able to accept engines for each of these and the suspension parts as series regulations dictated. For Formula Ford the Alford Alder or Triumph upright as its better known was used so this seemed a sensible option as parts are easily available, disc brakes could be fitted and it would fit with 13" wheels. Once I'd settled on the front suspension the next search would be for suitable wheels. The downside of the using the triumph upright is that the hubs have a PCD or 3-3/4" compared to the Hillman Imp hubs on the rear which are 4" PCD so I'd have to run a miss match front to rear. All the photos and articles I have of the car are are in it's earlier years where it ran JA Pearce Magna wheels so the hunt was on for yet another set. Well i didn't have to wait too long until just what I needed appeared on eBay from the same seller who I'd bought the uprights from a month or two before.

My son used to have a Kiwi girlfriend and it amused me when she said something about a 'chick book' and one of her friends having a lot of six. I tumbled to it eventually but she was history by then. Said Home Counties born son is now living in Sydney married to an Australian girl whose father was Chinese, and whose mother is ethnically Chinese but hailed from Vietnam and whose mother tongue is Cantonese. My God can she whip up a decent meal for a dozen people out of seemingly nothing though! With all that background to consider one has to tread very carefully indeed!

Think we’ve all done this. That’s not me, by the way, I’m much better looking.

I'll come along, just to say hello. Might see if Darve will get his car out of retirement too?!

Wheres Spike Milligan when you need him ? Anyone here ever read Puckoon

As the originator of this post, I’m from Irish ancestry, was born in London (actually a Cockney) and have a Scouse accent from my childhood in Liverpool. I also have quite a good sense of humour, am not easily offended and drive a Westfield. However I could get offended if someone tries turning an article into something it wasn’t meant to be. And how did brexit get into this post? But I’m not offended, quite the opposite, life’s too short. Rock on. As Bernie said, it’s called the British Sense Of Humour.

For goodness sake lets lighten up , as someone who is half Irish on my mothers side (from County Donegal ) which is indeed in the South (but its also in the North ) I have always loved something we British ( note the word British , not English or Irish or Scots or Welsh ) call " Banter " ( Oxford dictionary "Banter" the playful and friendly exchange of teasing remarks.) we are in danger of losing something unique to our race , its called " THE BRITISH SENSE OF HUMOUR " The best comedians in the world were, and still are, Liverpudlians , aka "Scousers " and Mancunians " Mancs" they are not alone in having a sense of humour which has helped to bring them through tragedy with an ability to laugh at the world and themselves when the going gets tough . I consider myself fortunate to live approximately halfway between the two tribes and can through my Irish ancestry understand and enjoy all forms of "banter"