Andy H Posted January 31, 2006 Posted January 31, 2006 Put me down for a silencer if it will fit onto a xflow inlet is 2" Cheers Andy.
pete g Posted January 31, 2006 Posted January 31, 2006 thanks for your hard work paul i personally wish to go for the full simpson system ,i have seen both systems in the flesh and the simpson one is far better quality .in fact is in a differant league to the finish of the sbd manifold.and if made to the same flow spec .then you can have the best of both worlds. also fitted with biggest silencer that will fit. count me in, ready, and decided on system. regards pete come on scott [simpsons]you know it makes sense
scott beeland Posted February 1, 2006 Posted February 1, 2006 I've decided and am booked in for March 6
pete g Posted February 1, 2006 Posted February 1, 2006 good man thats two for full simpson. need three more
Karl Woolf Posted February 1, 2006 Posted February 1, 2006 I`m leaning more to an SBD low exit system. Sloughs along way from cheshire
pete g Posted February 1, 2006 Posted February 1, 2006 karl if your engine is in standard position then no need to take your car .they can make two on either scotts or mine so should fit ok. if you live near scott take some measurements see if engine in same position or send them to me i will check against mine. believe me its far better quality .
Karl Woolf Posted February 1, 2006 Posted February 1, 2006 Pete, is yours a standard body by any chance
salexander Posted February 2, 2006 Posted February 2, 2006 I haven't seen any mention of 'mountings'! Will the exhaust cans have a built-in mount that will tie-in to the standard rear mount - or are we on our own?
Paul Ash Posted February 3, 2006 Author Posted February 3, 2006 Yes there is a mounting. Look at ht drawing on Page 3 of this post. Regards Paul
Flat Eric Posted February 3, 2006 Posted February 3, 2006 Paul Just about to send you an PM Count me in for 2 Silencer for my V8 2 1/2 inch bore - 29inch length Thanks Kevin
scott beeland Posted February 3, 2006 Posted February 3, 2006 Bonnet exit for me to SBD dimensions Roll on March 6th
scott beeland Posted February 3, 2006 Posted February 3, 2006 Roll up;roll up; roll up...........4 more names needed for a full simpson system. Mines booked in to be the build muse and I'd rather be paying £700 plus vat than £850 plus the vat!!!!!!!!!!!!!!!!!!!!! You know it makes sense
pete g Posted February 3, 2006 Posted February 3, 2006 dont for get me i want full bonnet exit simpson too
Recommended Posts