Leaderboard
Popular Content
Showing content with the highest reputation on 01/05/25 in all areas
-
The Warrington sub division can’t make it tonight I’m afraid. Ones broken his ankle the others torn a hamstring. Between @Megabusa Paul and myself we could make a Frankenstein’s monster driver but we haven’t found a doctor willing to do the cut and shut yet. Enjoy, it’s great weather for a blat!2 points
-
Given the current wonderful weather, the 'Stoke Rabble' will be departing from the pub, circa 30 mins from arrival to drive to the Cat and Fiddle. It would be great if some of the low mileage Cheshire brigade wish to venture out with us too. The route could look like this-
2 points -
Much of my workshop testing is done on the basis that it's not stupid if it works .. so may i present zetec induction length testing version 1.0 I will collate the results and put them in my westy repair and development thread. In the meantime have a giggle.
2 points -
Meet at Quacker's Cafe (gather.mango.tank) at 10am for a trot around the Peak District. It's a good, dry weather forecast but please wrap up, it's going to be a lot colder than this week has been. I'll have 300 layers on as usual 😁 Who is coming?1 point
-
My 1st attempt at polishing stainless steel. The manifold was all the dark tarnished colour before and the silencer pipe and end cap weren't quite so bad. Started with 120 grit and moved through to 2500 grit before polishing. About 7 hours in total to complete.
1 point -
Hi Hedley, I’ve just brought set off eBay but haven’t fitted yet price delivered 🤨
1 point -
The Wench getting her first proper outing of the year with a trip in warm sunshine to my favourite pub in Stratford on Avon. New front shocks providing a better ride. Roll on for Malvern and good weather!
1 point -
They should be escort MK 3 fronts, solid.1 point
-
When you've a free day, nice weather and a westfield! 110 mile round trip for lunch 😋
1 point -
Has to be one of the worst designs ever. Good news it was still in one piece and no debris in the oil, but changing that belt must have been a massive job - well done.1 point
-
Price reduced1 point
-
Hi WillC, If you are unable to get this.You can replace the pivot pin on the gearbox with a part from Kit Spares TRA0019, and then fit a standard ford release bearing. I have done this on a few so know it works Malcolm1 point
-
Sorry still no engine in the car.0 points
