Leaderboard

Thanks @Rednop1 These are Stunning

On a nice day like this, it would be rude not to. Pint of shandy in the sun🍺🌞

Wide track kit, just waiting on the longer brake hoses

Maybe

Off to test the new air filter cover

Think we should be ok for this 🤞see you there A&B

@Jakejmagee’s tiger has passed it’s Mot so is coming out to celebrate on Sunday!!

Yep. 😡 The main problems was lower rear right wishbone bolt was impossible to retract without removing the lower motor mount from the frame, which was held on by three nuts / bolts, two of which were inaccessible without obstruction spanners (see above). The lower motor mount was like sticking my hand into a freshly opened tin, sharp edges on both sides that cut me every time I reached in. Blood everywhere, but I don’t give up easily.

I've been thinking about ordering these for some time and finally got round to ordering them a week or so ago, and they arrived this week. I wanted a matching pair, and for my daughter to have the security of a six point harness to eliminate the risk of her slipping under the lap belts of the four point. I got the two free key rings (so I should think for the cost of the harnesses!) which match the car colours quite well. I've gone for the ultralite adjusters, and was very pleased with them when I drove to our meet last night.

Is that code for something else Mike? Car’s looking mint 👌

OOOOOWWWWCCCHHHH! 😱😱

Right side done apart from setting the ride height. Beer o’clock might be early today:

Took lots of thought but only one fixing. The doors sit happily on their own with just a single pin used as a pivot plus a bungy cord. Luckily I'm still flexible enough to thread myself inside 😀

How can you tell................. 😉 Excellent we'll look forward to seeing you!

If Rip Van Dowler is waking up, I might join you.....🙂

A set of half moon obstruction spanners from B & Q so I can finally remove the 22mm nut on the motor mount securing it to the frame. Said mount is blocking me from withdrawing the right bottom rear wishbone bolt that the original builder installed before he installed the motor mount, motor and bodywork, rendering access with a conventional spanner or socket impossible. This job is killing me bit by bit...

😳 you packing up Hannibal?

Did someone take a bite out of it, or is my eyesight terrible?

Recived mine rebuilded gearbox with new longer - 2.98 1st, new bearings, synchros, gaskets, seals, cleaned inside and outside. Now excercise and acrobatics to install..

Sorry andy going to Santapod Sunday so can’t make it!

F*** you dumb motor mount, back in at last after tearing my forearms and hands to shreds to remove and reinstall it: