Jump to content

Leaderboard

  1. Dave Eastwood (Gadgetman) - Club Chairman

    Dave Eastwood (Gadgetman) - Club Chairman

    Administrator


    • Points

      14

    • Posts

      42,206


  2. Simon Waterfall Syman84

    Simon Waterfall Syman84

    Speed Series Organising Team


    • Points

      13

    • Posts

      1,821


  3. Julie Hall - WSCC AO Representative

    Julie Hall - WSCC AO Representative

    Administrator


    • Points

      11

    • Posts

      3,835


  4. Baz456

    Baz456

    WSCC Member w/Mag


    • Points

      5

    • Posts

      260


Popular Content

Showing content with the highest reputation on 13/11/22 in all areas

  1. We were made very welcome at Quackers after our long absence, which was nice. A surprise visit from little Olivia was a pleasure, and she managed to bring mummy and daddy along too, known to us as @Simon Waterfall Syman84 and Michelle. Here we all are in Quackers cafe. Here are the cars, before Barry and Tom arrived. Unusually we had 2 bike engined cars with us today, which was good because Simon also races his bike engined car in the Speed Series. The bonnets soon came off in the car park, this is what club meets are all about, sharing knowledge and experience in this quite narrow field of expertise. My ideas of taking to the high roads of Buxton were dashed when I realised that we would be spending the day under a blanket of fog. The route, quite frankly, was made up as we went along. We headed West, found some brighter sky, headed for it, circumnavigated it, then decided we would go to a cafe that is normally too busy to get in. The Fountain at Bonsall, near Matlock Bath is a lovely cafe in a tiny village, it was still fairly busy but we just managed to squeeeeeze in. The Bonsall village car park. Barry and Tom had peeled off half way down the Via Gellia road, I hope you got home ok @Baslow. Glynn rang Ben from the cafe and he reported that Ben had made it home safe after signalling that he was turning off. Later we found out that he had broken a wing stay, haven't we all done that. The Fountain cafe, with our only remaining Andrew Cake Meister, the other Andy's have SORN....dirty word that, a dirty word, yuk. Cake Fever is spreading I got it too. Thanks for coming everyone, remember we are out on Saturday next weekend, at the car museum 'gathering' in Ambergate. I am sure we will tag a run out in search of cake afterwards, see you then x ON SATURDAY SATURDAY
    11 points
  2. Abit sketchy on the way over Beeley Moor to meet up! But at least help was nearby if needed this weekend! great run out, cheers👍
    5 points
  3. Todays run out to blow the cobwebs away
    4 points
  4. Thomas and I will be there... Mad dash to get everything ready as only just seen this! 🙄
    3 points
  5. @Glynn Walters that looks like Dads Army to the rescue 🤣
    2 points
  6. Hi all , we had a potential participant leave the group but had a new one join so still at 8 cars , room for more if you fancy it
    2 points
  7. This Facebook page is now live https://www.facebook.com/westfieldcarsofficial
    2 points
  8. First, I'd like to say a huge thanks to @Gail Jones for all her help and support in the Shows and Events role over the past few years, both pre and post pandemic. It's not been easy at times courtesy of the Covid situation. Gail has now stepped down, as we have a fresh volunteer to take over! I'd like to welcome @Marcus Barlow - Show and Events Co-ordinator to the role! Many of you will know Marcus well already, he's been a vital part of the Stoneleigh team for some years. As we are between elections/AGM's, as per the constitution, Marcus has been officially co-opted on to the committee until the next AGM. Thanks Marcus, and welcome!
    1 point
  9. I've been buying custom number plates for >20 yrs (usually legal font / style etc) but with minimal border (11mm all round the characters) usually due to owning registrations with lower than 7 characters etc. like the 305 x 110 mm plate shown below. I've just had plates made for my daughter's first car and can thoroughly recommend- https://www.fullhousecustoms.com/ not cheap and it's taken a week(I ordered at 5pm last Fri and they quoted shipment Mon/Tue- but was Thu, due to illness), but the quality is the best I've seen! We've bought fully legal plates with 3D vinyl letters and the BS kite mark and the plate makers name is in very small font on the plates(as shown below). Good communications via whatapp No comments from @Marcus Barlow - Show and Events Co-ordinator on my special Westie front plate please 😉 These won't be drilled and screwed, but fixed using 3M VHB tape. Here's the actual plates 3M reflective too
    1 point
  10. From proof back to bulletproof... Love a bit of Godsmack!
    1 point
  11. Big congrats @Marcus Barlow - Show and Events Co-ordinator look forward to promoting the events you have lined up. Big thank you to @Gail Jones also for services to the WSCC. Speak soon! ATB HB
    1 point
  12. Great to see a good mix of cars, sorry for your misfortune Ben, (though also worryingly pleasing to see not just Westfields affected by this issue. Oops!
    1 point
  13. I don't think that's a Westfield manifold. More likely a FWD car as per the above suggestion
    1 point
  14. enjoyed today in the fog till my cycle arch stay broke , bl**** thing lol , had to hit the smooth to limp home ...... made it home safe though
    0 points
  15. Even though I am not bolstering the Lancashire team this year, we have a secret weapon this year El Tel the memory man "The Fylde Coast Warrior"🤣🤣🤣🤣🤣🤣 Steve
    0 points
×
×
  • Create New...

Important Information

Please review our Terms of Use, Guidelines and Privacy Policy. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.