Leaderboard

P.M sent, cheers

Received mine on Monday, hand delivered by Mick! Very pleased with the quality Just need to find time to fit them!

I'd bolt a bit of aluminium on the outside of your bonnet to make the mould and proceed as Dave suggests. You could make the aluminium a good fit as it's curved IIRC and you would just need to fill the bolt holes when it's done. Please keep the look of your Westy authentic

5 years ago I had major issues with my internet, dropping out all the time, slow as anything. It took 2 weeks to convince them to send out a tech, it took him 10 minutes to fix the issue.......... Apparently what had happened was someone else had issues a few weeks before it all started, their issue was a physical line needed replacing inside the roadside cab, but instead of replacing it, some guy came out and swapped their connection onto mine, leaving me on their old dodgy connection. It happened just before Christmas and apparently they were all working "extra hard" to hit targets and earn their xmas bonus. A classic case of when you set targets, you only get what you measure.

Barny Using for testing is a good idea as no I would not use an RMD on the road or at all for thevreasons you say, I might be across MK on thursday if I could collect Cheers Chris

Look at a dyno chart of pretty much any standard engine and you see a little dip right at the point where emissions are tested...

Just need to replace those carbon effect cycle wings now ;-)