Leaderboard

My rear end squeaks are caused by baked beans.

Fingers crossed - you need some luck with Westys for a change!

Good luck!

I'll go into it with my mind open. The zetec westie I had, had about 130bhp and was perfectly adequate. Not sure if I can relate to the 'easy to work on' thing though, but it's reassuring to know I can give you a buzz

As Steve says, with a hot air gun carefully used. The material I used was acrylic (Perspex) and this is certainly easier than PC - and cheaper. I gripped it in my Workmate just below the bend line and heated each face alternately until it was soft enough to bend along the crease line. The Workmate made a useful jig to ensure a straight bend IYSWIM. It is a bit hit and miss if you're not careful. I was amazed at how well mine turned out given that I am pretty impatient and not known for nitpicking detail attention.