KugaWestie Posted March 21, 2020 Author Posted March 21, 2020 Yet more sanding and filling on the rear passenger arch I always seem to have a bit of filler left over, so I have started using the spare up on the front passenger wing
KugaWestie Posted March 21, 2020 Author Posted March 21, 2020 26 minutes ago, Chris King - Webmaster and Joint North East AO said: Labour of love Gary. Keep up the good work. 👍 Thanks Chris. It’s tough to keep going at times as it feels like it is relentless!
Dave Eastwood (Gadgetman) - Club Chairman Posted March 21, 2020 Posted March 21, 2020 Bodywork is always the same on restorations, too. It can be a grim relentless task at times, that feels like it will never end. It does though, and when the prep has been done well enough that it’s driven you to despair, you know that when you finally get it to paint, the end result will be stunning.
KugaWestie Posted March 22, 2020 Author Posted March 22, 2020 I sanded back again this afternoon and then applied a couple of coats of etch primer on the rear passenger wing The primer has shown up where some more fine filling is needed, so more to be done
KugaWestie Posted March 22, 2020 Author Posted March 22, 2020 I also sanded back the front passenger wing filler, so more to be done here as well now
KugaWestie Posted March 31, 2020 Author Posted March 31, 2020 It has been a few very tough days. My father got admitted to hospital last Weds lunchtime and sadly passed away Saturday Lunchtime, with the decision having to be taken to turn the support machines off. A victim of Covid 19 which brought on chronic pneumonia. It is so so sad. Nobody could visit, only 10 allowed to the funeral, not sure mum can attend due to her age etc etc. Really could not get much worse. On top of that we have had to furlough all our employees and have also decided to mothball the company until the end of April. I really don’t know what the future holds at present. So over the last few days I have been trying to keep myself busy pottering away on the car. On the passenger door I realised that I had cut away slightly too much of the moulding, so when the door seal was fitted it did not actually seal on the door. So I bonded a section of fibreglass onto the body Then I trimmed it and glassed over it Next job was to remove the door and start filling again
clansman Posted March 31, 2020 Posted March 31, 2020 So sorry to read your sad news about your dad Gary , these are very worrying times for everyone. Condolences to you and the family.
Alan Cutler (Adge) - Dorset AO Posted March 31, 2020 Posted March 31, 2020 Condolences Gary. Thoughts are with you and your family.
Kit Car Electronics and Essex AO Posted March 31, 2020 Posted March 31, 2020 Heartbreaking news, I'm so sorry for your loss, Gary.
Gary Taylor Posted March 31, 2020 Posted March 31, 2020 Deepest condolences to you at this sad time, words seem so insignificant, but our thoughts and prayers are with you
Recommended Posts