CraigHew Posted January 14, 2017 Posted January 14, 2017 So, how many carbon sets are you making for us fellow S2000 boys then Tom? 1
Ian Kinder (Bagpuss) - Joint Peak District AO Posted January 14, 2017 Posted January 14, 2017 13 hours ago, Tom (T3OMF) - Cotswolds AO said: Yes Russ Pm me your address, then when I finished with them, I'll post then on These could be come as widely travelled as Bob's legendary build stands 2
TAFKARM Posted January 14, 2017 Posted January 14, 2017 Yep, I'm forwarding them on to @matthew902 Not sure how much Royal Mail they'll withstand though!
Andy (Sycho) Posted January 14, 2017 Posted January 14, 2017 Jared (Tableleg) has offered to turn the templates into a PDF to share on here which may be easier when everyone's finished with them 1
Andy (Sycho) Posted January 14, 2017 Posted January 14, 2017 1 hour ago, RussH said: Yep, I'm forwarding them on to @matthew902 Not sure how much Royal Mail they'll withstand though! They are made of the finest cardboard 2
darve Posted January 14, 2017 Posted January 14, 2017 4 minutes ago, Sycho said: Jared (Tableleg) has offered to turn the templates into a PDF to share on here which may be easier when everyone's finished with them Well now that's a good idea 1
Thrustyjust Posted January 14, 2017 Posted January 14, 2017 I for one, know Toms got the carbon sheet already................... Although I managed to remove some carbon from his garage today He's got far too much of the stuff........ 2
Tom Frankland (T3OMF) Posted January 14, 2017 Author Posted January 14, 2017 4 hours ago, Sycho said: Jared (Tableleg) has offered to turn the templates into a PDF to share on here which may be easier when everyone's finished with them Great idea, I should be able to do the same which might speed the availability up 1
Thrustyjust Posted January 14, 2017 Posted January 14, 2017 Doodle me a set please Tom. I'll exchange it for very expensive engine breather fitting 1
Tim Reid Posted January 15, 2017 Posted January 15, 2017 Hi Tom, How are you going to do the corners as you appear to have flat sheet CF. Also, check the clearances on your car. I had to take 20mm off the WF kit as my rad is further forward in my nose. Tim
Tom Frankland (T3OMF) Posted January 15, 2017 Author Posted January 15, 2017 Thanks for that Tim, my rad is slightly thicker as well so I wont be making it as long if that makes sense. I won't be trimming the template though I have a plan for the right angle not sure if it's going to work or not yet
Tom Frankland (T3OMF) Posted January 15, 2017 Author Posted January 15, 2017 All masked up ready for the templates 2
Tom Frankland (T3OMF) Posted January 16, 2017 Author Posted January 16, 2017 On 11/01/2017 at 19:20, Tom (T3OMF) - Cotswolds AO said: OK, need help to deride Carbon on the inside or out side?? 1
Recommended Posts