salexander Posted October 26, 2011 Share Posted October 26, 2011 A pile of goodies from an ex grasstrack Duratec 235bhp engine: Throttle bodies 45mm DCOE type bodies, 88mm long. Complete with anodised alloy linkages, fuel rail, 90mm alloy trumpets (one has been a bit bashed at the lip and straightened, but is functional), Colvern throttle pot. These are Australian made bodies from’ EFI Hardware’, bit chunkier than the equivalent Jenveys, but do the job. SOLD Injectors Set of four Weber Marelli Pico injectors, 330cc at 3 Bar, high impedance SOLD Air filter Pipercross foam air filter with fibreglass baseplate and air temperature sensor. Baseplate has a few cracks and repairs, the filter has a couple of tears in the outer layer of foam. All a bit scruffy but usable! SOLD Fuel pressure regulator Weber alloy bodied regulator, 3.5 Bar. SOLD ECU MBE967Eg engine management system with map for 235bhp Duratec using above injection. Usual management of fuel, ignition, sensors, fan, lambda, launch, traction etc. SOLD Loom LM967 RWD – Professional rear wheel drive loom for MBE with all connectors and relays. Plug and play, saves a vast amount of time in producing a neat and reliable wiring setup. SOLD Duratec ported cylinder head, cams, inlet A complete Duratec cylinder head, ported by BPJ Performance with QED Q460 cams (296 degree), adjustable verniers, race springs and standard valves. Complete with a matched alloy inlet manifold. This should be capable of delivering at least 250bhp. £775 Duratec alloy wet sump SBD alloy baffled sump (SMP-5K-duracat), unmarked hasn’t been bottomed-out. Complete with standard dipstick and tube. SOLD Duratec crank pulley Standard steel pulley but with machined keyway. £10 Twin plate clutch Superclutch 700 Series 7 ¼” twin-plate clutch with sintered plates in good condition. SOLD All plus postage. I can supply photos of all of the bits. PM me or phone on 07771-722217 for more info. Stephen Link to comment Share on other sites More sharing options...
Recommended Posts