corsechris Posted December 5 Posted December 5 18 hours ago, Kit Car Electronics said: Took a voluntary redundancy/ early retirement deal so more time to play with cars and buttons (hopefully) My missus called that ‘retundancy’ when I took it a while back. I finished on a Friday, had the weekend off then started on the bathroom refurb on the Monday. Beware the ‘job list’ 3 Quote
joolz Posted December 12 Posted December 12 Had these dampers kicking around the workshop for a couple of years so thought I'd put them to good use. 4 Quote
Naranja_Al Posted December 13 Posted December 13 Fitted a 2lb Wilwood residual pressure valve to the rear brake line, disconnected and removed the old pressure brake light warning switch and fitted my new brake micro switch. Big thanks to @Greenstreak-Andy D & @Ian Kinder (Bagpuss) - Joint Peak District AOfor your help with the micro switch mount. 3 1 Quote
Ian Kinder (Bagpuss) - Joint Peak District AO Posted December 13 Posted December 13 Now get a rubber on this- details in my build thread recently........... 1 Quote
karinaxis88 Posted December 16 Posted December 16 On 05/12/2024 at 23:28, key750 said: What I have just done? Swapped a mini! What’s the new heart under the hood? Quote
key750 Posted December 16 Posted December 16 26 minutes ago, karinaxis88 said: What’s the new heart under the hood? Vauxhall e16se (1600 8V mpi), so funny... and enough dangerous 💣🤕 Quote
Mole Posted December 16 Posted December 16 On 13/12/2024 at 16:52, Ian Kinder (Bagpuss) - Joint Peak District AO said: Now get a rubber on this- details in my build thread recently........... I would be more worried about getting a split pin through the clevis pin rather than worrying about covering up! However I am sure it was just about to be done knowing Als attention to detail 🙂 Quote
Naranja_Al Posted December 16 Posted December 16 2 minutes ago, Mole said: I would be more worried about getting a split pin through the clevis pin rather than worrying about covering up! However I am sure it was just about to be done knowing Als attention to detail 🙂 Haha, yep. Clevis pin installed shortly after taking the picture 👍 1 Quote
GarethS09 Posted December 16 Posted December 16 Finally getting round to jobs Ive been putting off since I purchased the car. 3 Quote
Andrzej Posted December 18 Posted December 18 Ufff ... engine-gearbox out for lightweight flywheel and 2,98 1st gear instaltion. And maybe for some tidy up engine bay 5 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.