SteveB21 Posted yesterday at 14:53 Posted yesterday at 14:53 19 hours ago, Morris said: Apologies for the blatant self promotion, but my XI has featured in Issue 8 of 'Complete Car Builder' magazine (as has this club ). I thought the car and driver looked familiar! 1 Quote
Morris Posted yesterday at 15:14 Posted yesterday at 15:14 My 'Ace Café' beanie and safety specs weren't a good enough disguise then? Quote
Mole Posted 20 hours ago Posted 20 hours ago A fun well organized dry day at Blyton on Sunday... 4 Quote
Ian Kinder (Bagpuss) - Joint Peak District AO Posted 9 hours ago Posted 9 hours ago 11 hours ago, Mole said: A fun well organized dry day at Blyton on Sunday... Looks like you're pulling some 'G' there, @Mole Martyn. Quite some roll on the car (though the left side is well on the kerb)! Quote
Mole Posted 9 hours ago Posted 9 hours ago 5 minutes ago, Ian Kinder (Bagpuss) - Joint Peak District AO said: Looks like you're pulling some 'G' there, @Mole Martyn. Quite some roll on the car (though the left side is well on the kerb)! Thanks Ian.. I have put slightly stronger springs on but still soft.. and it has reduced the roll a little and improved turn in.. The cheap Kumhos were hanging on ok too!! 2 Quote
Mole Posted 3 hours ago Posted 3 hours ago 4 hours ago, Naranja_Al said: Until I broke it…! What have you done? Quote
Naranja_Al Posted 3 hours ago Posted 3 hours ago 5 minutes ago, Mole said: What have you done? Not entirely sure yet, but my clutch has given up the ghost. It started slipping coming out of the Esses in 3rd and 4th gear. A couple of laps later chasing a 420R, something went, resulting in a bad vibration through the gearstick / tunnel and gear selection become very difficult. Quote
7Westfield Posted 2 hours ago Posted 2 hours ago 32 minutes ago, Naranja_Al said: Not entirely sure yet, but my clutch has given up the ghost. It started slipping coming out of the Esses in 3rd and 4th gear. A couple of laps later chasing a 420R, something went, resulting in a bad vibration through the gearstick / tunnel and gear selection become very difficult. You may have stripped some lining off the clutch disc. Similar happened to me years ago. Flat out in 2nd, went for 3rd, got 1st instead. Large pieces of lining went into the springs of the cover, and jammed it up properly. Extreme vibration. Lucky the over-rev didn't hurt the motor. Quote
Mole Posted 1 hour ago Posted 1 hour ago 1 hour ago, Naranja_Al said: Not entirely sure yet, but my clutch has given up the ghost. It started slipping coming out of the Esses in 3rd and 4th gear. A couple of laps later chasing a 420R, something went, resulting in a bad vibration through the gearstick / tunnel and gear selection become very difficult. Hopefully nothing too bad.. Good job you are experienced at getting engine in and out! 1 Quote
Mike Rowland - Essex AO Posted 55 minutes ago Posted 55 minutes ago My roll cage windscreen has worked well for some years now, so I fancied adding windscreen deflectors using a similar clamp idea( @KevanP has done similar). Nearly as much weather protection as I had 30 years ago oh well 1 Quote
jasesonix Posted 15 minutes ago Posted 15 minutes ago Went to Blyton twice last year in my westy. Loadsa fun but had setup issues with my suspension. After 1st time i stiffened the springs a bit thinking it would make quite a difference but still found it hard to turn in. Will have to keep experimenting i think. Good track though for the Westies Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.