Jump to content

Quinten's Mighty Blog

A blog by Quinten in General

  • entries
    64
  • comments
    22
  • views
    78,636

November 2016

Quinten

Entry posted by Quinten

1,792 views

 Share

November 5th, 2016

Spend: £0.00

 

Got the roll bar off using some heat to soften the glue and a putty knife to wedge in between bar plate and body work. Then started to work on the new carbon boot sides.

 

2016-11-05+13_08_22.jpg

 

Once I got the holes right, the rest was just fine tuning. Now just the filler itself to do, but I will wait until I've been to the welder to see what is possible

 

2016-11-05+16_03_32.jpg

 

November 6th, 2016

Spend: £28.98

 

Fixed the brake line in the tunnel back using rubber lined P-clips, and replaced one or two broken saddle clips with new ones. Fitted the conduit and pulled wiring from the scuttle to the rear.

 

November 12th, 2016

Spend: £17.67

 

Continued with wiring at the rear.

 

November 13th, 2016

Spend: £5.58

 

2016-11-13+16_11_45.jpg

 

Finished most of the wiring at the rear.

 

November 20th, 2016

Spend: £13.50

 

Further completed the boot side panels and reduced width of handbrake load spreader as it was rubbing against the wiring loom.

 

2016-11-20+16_10_13.jpg

 

November 25th, 2016

Spend: £50.00

 

At first I was not going to touch the roll bar, then I briefly considered painting it myself, until I had a quote from a local powder coating company to have it properly done.  Collected it today and it looks like new :yes:

The only snag is that I didn't remove the rose joints and the rubbers on them cooked in the oven.  Another thing to replace!

 

 

 

Last month: £  3381.62
This month: £   115.73
            ----------+
Total:      £  3497.35

 Share

2 Comments

Recommended Comments

Olliebeak

Olliebeak 111

Posted

Like the boot sides, what do you intend to do in the middle? I am looking to do something similar myself when I remove my RAC bar and fit my lovely chrome one. I butchered the sides of my boot boot when installing around the RAC bar and covered it up using carpet. I suppose that you could just cut the sides off the existing boot box and make it easily removable for access.

Link to comment
Quinten

Quinten 1,776

Posted

30 minutes ago, Olliebeak said:

Like the boot sides, what do you intend to do in the middle? I am looking to do something similar myself when I remove my RAC bar and fit my lovely chrome one. I butchered the sides of my boot boot when installing around the RAC bar and covered it up using carpet. I suppose that you could just cut the sides off the existing boot box and make it easily removable for access.

 

A boot lid.  I'm not actually fitting a boot box as I don't really need it, but I do prefer to be able to access the rear from the top.  The boot lid is still a long time off though, so I'll be re-using the tonneau cover for the moment and just lifting it at the corner when I need to fill up for petrol ;)

Link to comment
×
×
  • Create New...

Important Information

Please review our Terms of Use, Guidelines and Privacy Policy. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.