BobM Posted January 28, 2003 Posted January 28, 2003 Thanks Bob, exactly what I was looking for! Any chance you could pull out a tape measure and let me know exactly where these little b*******s need to be welded? The bosses for the harnesses are a fraction under 13cm apart, centred on each seat. 32.8cm between the two middle ones, outer ones about 13cm in from outside of chassis rail (I say about cos you can't see the chassis rail with the body on). All measurements to centre of bosses. And no, I'm not taking the bl**** body off to measure the rollbar stay mounts for you Quote
POC Posted January 29, 2003 Author Posted January 29, 2003 most folks seem to "wrap" em around the side Thats good enough for me, for now anyway, suck it and see eh. Thanks again Mark, oh ye fountain of knowledge.... you might also want to consider welding some stifners in behind the mounts down to the diff area Are these needed then? is there much flex in the chassis or are you thinking just be that little bit stiffer / safer? The bosses for the harnesses are a fraction under 13cm apart, centred on each seat. 32.8cm between the two middle ones, outer ones about 13cm in from outside of chassis rail (I say about cos you can't see the chassis rail with the body on). All measurements to centre of bosses. Fantastic Bob, thanks alot for that mate! And no, I'm not taking the bl**** body off to measure the rollbar stay mounts for you Damit! Thanks for all the help guys, the parts should turn up today so I shall be in the garage this eveing poking about, scratching my head and coming up with a load more questions. Cheers paul Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.