tex Posted March 13 Posted March 13 Similar to this or narrower. I need to expel hot air under V8 style engine cover a bit better. Suffered heat soak last summer after lonnnng hot days driving hard then hitting crawling traffic.. So removing said trapped air will help
DeanMegaS2000 Posted March 13 Posted March 13 Could try in the 3D printing section. Good little project for someone. I'm new to it so don't have the skill to draw honey comb yet.
GarethS09 Posted March 13 Posted March 13 24 minutes ago, DeanMegaS2000 said: Could try in the 3D printing section. Good little project for someone. I'm new to it so don't have the skill to draw honey comb yet. Still a work in progress on mine but if you check the downloads section there are 3D models already available. https://forum.wscc.co.uk/forum/files/category/112-the-mofast-files-an-archive/ I wanted mine to fit from above rather than underneath like the existing available models. For honey comb I used a free model online and just trimmed it down to fit the vent. 1
DeanMegaS2000 Posted March 13 Posted March 13 30 minutes ago, GarethS09 said: Still a work in progress on mine but if you check the downloads section there are 3D models already available. https://forum.wscc.co.uk/forum/files/category/112-the-mofast-files-an-archive/ I wanted mine to fit from above rather than underneath like the existing available models. For honey comb I used a free model online and just trimmed it down to fit the vent. What a great idea cropping another model. I'll have to try that.
GarethS09 Posted March 13 Posted March 13 5 hours ago, DeanMegaS2000 said: What a great idea cropping another model. I'll have to try that. honeycomb_mesh.stl Here is the free mesh I found and used.
Recommended Posts