Clutch release bearing

[Ortyn]

Just wondering  this difficult to get a simple clutch release bearing for a Westfield. I thought the company still selling theese. They are not available on the site. May I am wrong the MT75 gearbox was the replacement for the type 9 but they only sell bearing for the type 9 what is much smaller. Do anyone sell one of theese?
I want to reassemble my car but a simple part blocking me doing that.

[Mike Rowland - Essex AO]

That seems to have an extension - discussion here about using a 19mm spacer versus moving the pivot pin to an extended one:

 

https://www.locostbuilders.co.uk/viewthread.php?tid=219124

 

https://kitspares.co.uk/products/mt75-clutch-arm-pin

 

 

 

[Ortyn]

Yes, 

 

Someone sent me the same info so may the longer pin could work. 

Today I took a closer look again and seperated the spacer from the bearing. Doing this just been using a flathead screwdriver and prying apart. It was quiet easy. 

Actually the spacer is a simple part, attached properly to the bearing. 

I ordered a replacement part from LUK and I will try the same thing with the brand new bearing (prying apart) and will reattach the spacer onto the new bearing. 

I am not sure if it will work but I will give it a try. 

Will upload the result. 

If it fails then I will order the new, longer pin. 

 

Many thanks for the links! 

 

[Ortyn]

Many thanks!


Today I tried to clip the brand new release bearing and its been connected properly. (after I realized the back of the bearing is not the one I need to the clutch fork)
So must order another bearing -exactly the same and will do it again. Should work but I was stupid and been ordering the wrong bearing.
Thanks for the link anyway 

[Ortyn]

Anybody knows what part is this?
found one on ebay and it says aircon evaporator 
Sitting on the side of the zetec...

[Mike Rowland - Essex AO]

Positive Crank Vent (PCV). Connects with a vacuum hose to an oem intake plenum. You can vent it to a catch tank or remove and blank off with a plate. 

[MR.C]

The extension on the bearing is a tight fit (interference)looks to me like your dismantling the bearing.

i made an extension for mine but never used it.

The extension stops the bearing leaving the support tube (the bit that covers the main shaft)