RAC type roll bar braces

[Martin Letts - Joint Hampshire & IOW AO]

As in the heading, I’m after the two braces for an RAC type roll bar, anyone got them hiding in the man cave?

[Richard (OldStager)]

I can't promise anything Martin, but I removed mine years ago, if I still have them they could be anywhere, so leave it with me and I will report back tomorrow.

 

Richard.

[Martin Letts - Joint Hampshire & IOW AO]

Thanks for looking

[Richard (OldStager)]

Sorry Martin, I have looked everywhere. I think they went out with the rest of the 'scrap' metal during a clear out last summer. I did find some of the rose joints though - useless I know but still.

[Tuner58]

I have a pair handy for measurements , 38mm CDS 700mm tube length , 4 weld in threaded boss`s with 1/2" UNF rod ends

[Richard (OldStager)]

1 minute ago, Tuner58 said:

I have a pair handy for measurements , 38mm CDS 70mm tube length , 4 weld in threaded boss`s with 1/2" UNF rod ends

Wish I hadn't binned mine now, trouble is you can only hoard so much stuff....

I think you mean 700mm though?

[Tuner58]

Your right , amended ( must learn to read before pressing enter !! ) Not sure I`m going to use mine , but need to get the car further before I decide ( probably just buy some CDS and weld new back stay`s in )

 

[Richard (OldStager)]

LOL, no worries, just in case someone ran off to get some made, then got a shock when they collected them 🤣

[Tuner58]

Not much call for a tenth scale roll bar !! LOL

[Richard (OldStager)]

Might come in handy if I make another model this winter 😁

[Martin Letts - Joint Hampshire & IOW AO]

Thanks for the measurements

[Martin Letts - Joint Hampshire & IOW AO]

So where are you in the country, Tuner58? 

[Tuner58]

South Wales , just outside Cardiff mate