Zetec exhaust manifold-found-

[DamperMan]

I had a Westfield 4-1  one but in the original engine position the wheel arch would rub it.  So I made my own out of a sT170 4-2-1 manifold and sold the proper one... now a few years later the engine is further back and I have wide track..    Now before cutting my new shiny carbon flared sides I’m wondering if anyone has a decent zetec exhaust manifold preferably with a 2.5 tail.   Dunnel/ Raceline/ etc

[NigelO]

can't help with a manifold, but you should be aware that the standard Westfield manifold for the Zetec is VERY close to the flared side panel (to the point where heat will be an issue)

 

 

[Kingster]

1 hour ago, NigelO said:

VERY close to the flared side pane

Depends on install perhaps. I think I’d have plenty of space?

 

[DamperMan]

Thanks... I'm just seeing what is out there and if there's nothing suitable i'll probably make my own.   TIG at the ready 

[Nick Lester]

I have a Raceline 4 - 1 manifold for a Zetec that I am looking to sell, I will PM you some pictures. One thing, your post above says you need a 2 1/2 inch tail, the diameter of the outlet pipe on the Raceline collector is 2 1/4"

[NigelO]

34 minutes ago, Chris King said:

Depends on install perhaps. I think I’d have plenty of space?

 

 

Good grief - that's a lot further outboard than mine - do you have a 12" diameter silencer?

[Kingster]

1 hour ago, NigelO said:

 

Good grief - that's a lot further outboard than mine - do you have a 12" diameter silencer?

Haha nope - but silencer runs parallel 

 

[jonjh1964]

Tony,

SEIW Zetec, Westfield 4:1 manifold and 50mm flare on the side panel.

[DamperMan]

Looks like I’ve been offered what I need :)... sorted :)...     The “fun” but I’m sure will be tweaking the Map to be right with the different characteristics.