Type 9 Ally Bellhousing (SOLD) + Lightweight Flywheel (SOLD) and 7.5" Clutch for Pinto / Cosworth.

[Blatman]

Following the breaking and sale of my sprint car I have the following "left over"!!!

 

1 x Aluminium bellhousing for a Type 9 gearbox. It's from a Morgan... I never fitted it so it's in the same condition in which I bought it. NOTE... It's 150mm face-to-face depth which is right for the short input shaft type 9. £100 + P&P *Now includes a hydraulic clutch slave cylinder. SOLD

 

Second, there is a steel "skeleton" flywheel with Pinto ring gear. This weighs in at around 3Kg's and when attached to the Cossie meant it revved like a bike engine, only better  

This will fit a Pinto or a Cossie and was one of the best mods I ever did.

I put about 50 miles on this before I stopped sprinting and as I was in the road going class it didn't hasn't endured any abuse at all! £120 + P&P SOLD

 

Finally there is a matching twin plate clutch WITHOUT friction plates. This is from Superclutch as can be seen. Again, about 50 miles and a decade or so of storage is all the action this has seen. Yes the surfaces of the intermediate plates could do with a good clean but apart from that it is in full working order. The closest thing I can find to this is from Quartermaster and they're over 500 quid, so £200 + P&P

 

 

 

 

 

 

[TAFKARM]

That flywheel looks lovely!

[Blatman]

29 minutes ago, Rush Motorsport said:

That flywheel looks lovely!

 

And for a century-and-a-half all that loveliness can be yours... 😄 

[Blatman]

BTTT

[Blatman]

Back to the top as I still have these and I am keen to shift them. I have updated the openining post with price reductions and provenance info.

Additionally I have an hydraulic clutch slave cylinder for the bellhousing/clutch that will be familiar to many of you. I'll throw it in with the bellhousing because it will likely need a seal kit throwing in.

[Tuner58]

I`ll take the bellhousing if you can work out P&P

[NDS]

PM sent 

[Blatman]

4 hours ago, Tuner58 said:

I`ll take the bellhousing if you can work out P&P

 

Where in the UK are you? I could spend quite a lot of time with bubble wrap and a box that I would rather spend having a drive somewhere  

[Tuner58]

6 minutes ago, Blatman said:

 

Where in the UK are you? I could spend quite a lot of time with bubble wrap and a box that I would rather spend having a drive somewhere  

PM sent

[Blatman]

BTTT - just the 7.5" clutch cover and non-friction plates left to go.