Crossflow short intake manifold for 40 dcoes

[nice_guy]

Hello,

I'm looking for a short manifold in order to fit 40mm dcoes on a 1600 crossflow.

The shortes / lowest profile and flattest angle would be best, but I'm ready to machine. 

I think the best one was made by "Hi-flow" (shows in the casting).

(a nameless one is currenlty fitted, 65mm length, 34mm rise, 5° angle, and it's too high)

 

Thanks a lot !

[KenP]

If you can't find what you want and need to by new have a look here.  They can make what you need to get the carbs under the bonnet. 

[NDS]

Have a couple spare from our supercharged project. Will send some photos later today. Do you want them straight or angled?

Neil 01738 550005

 

[nice_guy]

4 hours ago, KenP said:

If you can't find what you want and need to by new have a look here.  They can make what you need to get the carbs under the bonnet. 

Yup, Danst was considered multiple times along my journey.

[nice_guy]

3 hours ago, NDS said:

Have a couple spare from our supercharged project. Will send some photos later today. Do you want them straight or angled?

Neil 01738 550005

 

I still have a distributor to clear, so it needs to rise "a bit" : a ruler in the picture would help knowing if that fits under my cramped engine bay.  I assume straight item was fitted with a fully electonic ignition ? (now I will look at that supercharged engine)

[NDS]

Please find attached photos of the two inlets I have in the workshop. The first is a regular cast manifold but it has been polished and gas flowed. The second is a fabricated one made for high flow.   You can fit a distributor under the manifolds by using a 90 degree cap. They are available from Burtons. The last two photos are of the super-charged crossflow  its a monster! running Jenvey throttle bodies , DAT engine management , Huge intercooler and methanol/ water injection. All packaged into a seven . You can see the increase in the inlet manifold angle