Wanted: Lightweight Zetec Flywheel

[dhutch]

What have you got?

- Not looking for anything superlight, and am not sure what I think about machined down cast flywheels, but open to consideration.

Daniel

[blue ass fly]

Get yourself a late cvh efi fw daniel

Just over 6 kg and have marks for crank sensor

Same bolt pattern , just drill out to 11mm

Clutch bts the same

I use one - pickup is amazing

[dhutch]

Get yourself a late cvh efi fw daniel

I have heard this before, even as crude as people using a piston drill to open out the holes.

How can I tell what I am buying when looking on ebay? Is it for instance the case that any CVH with timing marks will be a late efi spec one? Is the ring gear on this correct for rwd setup? What clutch does it take? Anything else to look out for?

Daniel

[blue ass fly]

A pillar drill will open the hole up

The steel isnt hard

Bolt pattern is the same as 1800 zetec so you use a 1.6/1.8 early mondeo clutch - that will have the same splines as a type 9

Or have it drilles to take a pinto clutch

Ring gear is the same so re use starter

The fw will have the timing marks on the back

Ime sure ive got photos somewhere-ille dig them out

[blue ass fly]

Here you go - ive even found one for you

Ebay 282018180832

[dhutch]

A pillar drill will open the hole up

The steel isnt hard

Bolt pattern is the same as 1800 zetec so you use a 1.6/1.8 early mondeo clutch - that will have the same splines as a type 9

Or have it drilles to take a pinto clutch

Ring gear is the same so re use starter

The fw will have the timing marks on the back

Ime sure ive got photos somewhere-ille dig them out

Here you go - ive even found one for you

Ebay 282018180832

Thank you.

Will that bolt pattern match with the CVH flywheel (which I understand my be from a fwd cvh ?) I currently have on old engine? Or did they change throughout the years?

Daniel

[JulianE]

That will fit fine once you have corrected the hole size , as Steve says that is the only issue

[blue ass fly]

[CL290005]

I have a cvh flywheel drilled to fit Zetec if your interested

I just need to dig it out

[dhutch]

I have a cvh flywheel drilled to fit Zetec if your interested

I just need to dig it out

PM sent.