Search the Community
Showing results for tags 'starter'.
-
Zetec Blacktop 2L, standard Westfield kit using OMEX 600 and standard loom. Coming to the conclusion that the starter solenoid trigger signal is not man enough if battery not tip top, due to voltage drop through all the resistance in the circuit wiring, 5 joints from start to finish plus the ignition key switch. If the battery is at peak performance I think it can hit the solenoid with enough to get it engaged, otherwise just the click. Was thinking of adding a relay, with trigger wire closing it and direct fused feed from battery on the switched side. I could install it in the engine bay near the starter say near the washer bottle. I have seen this as a solution on 70's classics like 240Z. Has anybody else done this, does it sound a daft idea ?
-
S2000 builders, do you run your positive lead to the starter along the left side of the engine bay or with the rest of the wiring around the right side? Do you know what length the cable is? I can't find any info on this in the manuals or on the forums
-
Morning all, its been a while since I took the cables off and I didn't take a picture. Can anyone help with the correct location for both starter and alternator? Additionally, on the starter motor end, where does the earth from the chassis bolt to? Is it through the bell housing caphead bolt or to the hex head that goes into the block?
-
For sale are a series of Blacktop 2.0 Zetec used parts in good condition. My original plan was to recondition and tune the engine, but instead I bought a complete, new unit, so all these parts are now surplus to requirements. (Prices in Brackets are the current new prices at Burton Motorsport) Blacktop Raceline Sump - Exhaust side starter motor £250 (£532) Sold to CRAIG R Blacktop Raceline Water rail - including fitting kit and thermostat & housing - £150 (£285) Sold to Kernow Still for Sale Starter Motor -Exhaust side £50 (£156) Flywheel & Clutch assembly £50 ( ) Blacktop Rocker cover £20 Ignition Coil Pack and leads £30 (£80) Cylinder head & Std Cams £100 (£160 surcharge for cylinder exchange, Cams ??) Block, rods, pistons & crank - make an offer Currently all the remaining bits are bolted together, but I am not selling it as a 'runner' - just as spares or for reconditioning. If you want all the rest of it, it's yours for £200 - collection only from Norfolk please. (Happy to post bits) Any questions please PM me. Thanks Jason
- 7 replies
-
- Cylinder head
- Raceline
- (and 4 more)