Search the Community
Showing results for tags 'sound'.
Found 3 results
-
Ever wondered what the WSCC Peak District members are up to at the weekends. Take a look & make sure you join us for drinks, cake, more cake & great conversation.
-
-
OK,this has been on my mind for a while, but I'm quickly reaching the point of having to make a decision,as I'm now very close to dropping my chassis off the tresses to axle stands, ready to try to fit the engine. I have taken note of Dave's thread where he fitted this Dynamat heat & sound matting to his cockpit and very much like the idea. So I'm at the point where if I'm going to fit something like this, I have the opportunity to fit this on the in-side of the tunnel paneling, before I fit the prop-shaft and engine/gearbox. Has anybody through, or even done this,and do the forum think it's worthwhile? Dave - if you had the choice would yo have fitted on the inside of the tunnel? Now I'm assuming Dave did this for a very good reason,and while I could follow his excellent idea on the floor of the cockpit, If I were to fit this on the inside of the tunnel panels, I think I would be saving a bit of hassle and room for the driver/passenger as lets be honest, I like my food. I could then apply the same logic on the inside of the outer panels. Be very grateful for any thoughts, if anybody has done this in the past,what material was used, how hot does the tunnel get in something comparable like the S2000 to my sport 250
