Leaderboard

Hi All. Will do another run of calendars for everyone in this post at the weekend. They can sometimes be delayed, so was just waiting to see if they turned up! Thanks Mat

For sale, One TRS 2", 4 point harness and two sets of shoulder pads. Fitted with their top of the range Ultralight aluminium adjusters. Without doubt the best modification I made to my car. The standard harness with steel adjusters was hopeless alway loose and unsafe. With this harness I was finally tight in the car and felt part of it. Able to adjust the harness on the move with one hand for the twisties. I only replaced the drivers one, because of the cost and I also drove solo anyway. I fitted pads to both sides so that they would match. £80 delivered

For sale, quality Carbon Fibre Diffuser for an FW. Purchased from AJM Design and a piece of beauty. Really does finish off the back of an FW In excellent condition with no marks or cracks. I have drilled 4 holes for fixing, which was the least I could get away with. 2 are just visible and the lower 2 are unseen. You can use these holes as a template. I have included 4 new pan head bolts and the rubber trim. £200 delivered by DPD

For sale, brand new and unused Zetec Blacktop alternator bracket. After suffering 2 bracket failures I decided to purchase another new one from Westfield and have it reinforced and strengthen in the 3 areas the previous ones had failed. I spent an additional £100 having it fabricated and powder coated, to put an end to the problem. £70 delivered https://www.westfield-sportscars.co.uk/shop/2942126b-zetec-blacktop-alternator-mounting-bracket-7754#attr=

@Mathew Vernon - Membership Secretary can you help?

I highly doubt that's possible with a supercharged F20, the engine itself is quite heavy, plus you have all the supercharging bits, rotrex, its oil (sometimes its cooler), intercooler, etc. That is hard to obtain even on a supercharged Duratec, which has a significantly lighter engine...

I have a carcoon and its not heat that dries your car but dehumidifier through carbon filters its also 100% waterproof with fully attached base double skinned to prevent ice forming inside has a useful opimate type charging system to keep your battery in top condition and should your external power fail it switches over to the car battery and stays inflated, after 3-4 months in there even discs stay shinny like the day it went in I think it would be hard to create the same environment with a poly tunnel i think it would suffer huge condensation issues

A good way to protect against that is a carcoon. They're not that expensive tbh.. £400ish new. I reckon one can be made cheaper.. Using poly-tunnel plastic sheeting which isn't expensive. 2x2 wooden framework, staple gun and join the plastic with velcro. For heat. Initially use a diesel heater ducting into the 'bubble' for drying out. Then switch to a few 12v computer casing fans blowing instead. It'll need to have venting the opposite side. When not in use... Roll up the sides, fix to the roof joists. 12v fans powered by a transformer which can also power any LED strips inside if needed.

Unlikely the many messages I got about being on the front of the 2026 Calendar, I've only had one member advise they've seen this on Instagram. https://www.instagram.com/p/DTcl17iiEVA/ https://fb.watch/EMYg-bYUrl/

I do understand and wouldn't pass on anything unless the owner said it was Ok. Thanks.

I've just renewed with Howden for the 12th time. £10 cheaper than last year So I'm more than happy! Great service from Luana Profor.

It looks like the O.P. has already gone SORN!