All Activity

@Andrzej’s compressor sells as an RAC branded item in the UK but without the nice little storage bag. The hose is very short and the 86cm lead can plug into a 153cm lead with cigarette plug or 108cm lead with small croc clips. With the cigarette plug lead the unit will easily reach front and back tyres using a power socket in the cabin, but it won’t reach the rear tyres using the croc clips on a front mounted battery. Having said that you would probably want to upgrade the croc clips anyway, so easy to add an extra length of wire at the same time. The unit says it is 12v 100w, but I’ve not checked the actual current draw.

I’ve got one I can sell you for a very reasonable price. Reasonable in my opinion, of course.

Currently investigating a dead AUU 1040 PIC (ignition) module out of a Morgan. Apparently this version is very rare. Hard to imagine a Maestro/Montego engine part being rare, but they didn’t make many of these specific ones it seems. I might be onto the fault….will post a follow up when the new chip arrives and I've tested it. Fingers crossed. Had to find the Arduino Uno I’d programmed up with ‘Ardustim’, a crank & cam signal generator. Remarkable what things are out there, for free. Pretty sure I’d have struggled to program that myself!!

These are what I'm going for. I think many people here have them. After 12 years of kit car experience I'd say to go for the better Superlite or Ultralite adjusters if you can run to the expense as in kits getting the standard ones to slide easily can be a nightmare. https://www.cobraseatsshop.co.uk/trs-westfield-pro-6-point-fiaroad-harness-4949-p.asp

https://www.cobraseatsshop.co.uk/westfield-harnesses-326-c.asp

I can assure you I haven't! Ah-ah-ahhhh! 😁

They do a Sunday get together as well. Just mixing it up.

My spares stash is not quite as comprehensive as I thought but I do have the following, all unused and with original packaging: 2 x FW LED stop/tail lights 2 x FW outer reflectors 2 x FW inner reflectors Total price from Westfield is £206.44 + postage but I'm sure the same or equivalent can be had from Ebay or elsewhere for perhaps 2/3 of that price. I can let them all go for £100 including postage.

Shame they hold this on a Friday, especially as roads on Friday evenings are never the quietest

What is ‘MSUK Approval’ standard. I have 4 point but they are not fia standard. Not sure if they are MSUK Approved. Where is the best place to buy 4 point and/or 6 point? And what should I be looking for to fit a Westfield. (I know 6 point is better) Thanks

Great British Sportscars are holding their last Friday night at the Factory event for this year on the 8th August from 5 till 9. &nbsp Address and details on the photo below. Pizza and cake were both exceptional at the last event!! Hopefully see you there.

You’ve led a sheltered life!

What's with the singing Captain? 😂

I'll take a look tomorrow to see what I've got and let you both know.

Hi Bob, Currently building an FW and looking at fitting LED lights instead of the stock ones supplied with the kit. How much are you looking to get for them? Thanks!

Thanks Bob, its the front light brackets. I've found the new version at westfield so I may bite the bullet and get 1 side, see how it fits. If ok then get the other side. Do u have a pic of the lights? Any wiring with them?

Has my shirt finally met it's maker? 40th next year.

Which lights do you need? I have a set of unused Westfield FW LED rear lights and reflectors.

I have one that has not been fitted, powder coated black. Can get it out if you're interested. PM me.

Iam after a standard roll bar for a seiw as picture attached, located north dorset thanks dan

One! One 45 oz dead blow hammer! Ah-ah-ahhhh!

Two hundred! Two hundred cheap little rubber O rings! Ah-ah-ahhh! There is a Wench project or three going on and if they’re successful, I’ll reveal them. But if they’re not successful, you’ll never know why I’ve bought them.

😁👍

That reminds me, my wife informed me a couple of weeks ago that the youngest recently "borrowed" the compressor I carry in the Westfield for his pimped up Corsa...... Time for some Amazon shopping therapy as I can guarantee to never to see that particular compressor ever again!

Been doing a bit of dyno work again, this time on the effects of filter socks on hp. results in my development thread.