All Activity

I have one that has not been fitted, powder coated black. Can get it out if you're interested. PM me.

Iam after a standard roll bar for a seiw as picture attached, located north dorset thanks dan

One! One 45 oz dead blow hammer! Ah-ah-ahhhh!

Two hundred! Two hundred cheap little rubber O rings! Ah-ah-ahhh! There is a Wench project or three going on and if they’re successful, I’ll reveal them. But if they’re not successful, you’ll never know why I’ve bought them.

😁👍

That reminds me, my wife informed me a couple of weeks ago that the youngest recently "borrowed" the compressor I carry in the Westfield for his pimped up Corsa...... Time for some Amazon shopping therapy as I can guarantee to never to see that particular compressor ever again!

Been doing a bit of dyno work again, this time on the effects of filter socks on hp. results in my development thread.

Nice engine 😄 How does it go in a Westfield? Yours is probably the first one I see in the UK...

Sorry, my pal wanted 45’s and found a set yesterday!

What colour do you need?

Any suggestions for where. i may obtain o/s rear wheel arch for a wide body 2004 megabusa ? thanks paul

sorry for the delay in replying been away .. yes i still have them ..message me

Sold

Our car won the competition at the museum and the official photo's are in. The Great British Masters of the Marque, sponsored by Wera Tools, not bad for a 22 year old car that has done 76,000 miles, the polishing was worth it Glen! The prize It's the attention to detail also, little things like replacing the steering rack bushes. Ordered one day on-line from Westfield Chesil Ltd and delivered the next day, I might add, fantastic service. These are the 'before' photo's The 'after' photo's The one on the left was a very tight fit and will have a bit of attention tomorrow before replacing the nose cone. Your turn to win the competition next year!

And details of the recent full service:

A few people have asked for the dimensions so I thought I’d post them here too: Internal bed width: 195cm Internal height: 153cm Internal length: 430cm Wheel channels are 40cm on each side

Hi again. This is a bit frustrating. I am now looking for lights and headlight brackets. Can anyone help? Thanks

Sorted thanks. Was originally after a cheapy as planning on going to 13's at some point

DMing you now Al

Bang on, 59mm according to Google.

Ok ta. How deep are they Al? 59mm ish?

Steve, I used to live on Dudley Road in Walton-on-Thames, and then Fieldcommon Lane (Bandit country! ) not so far from you.

Thanks very much - I’ll have a look

They came off my ST170 (Zetec block) so they will fit

Thanks, please let me know when you get back. Those dimensions are a bit confusing as the seat back is shown as narrower, but dimensioned as wider - weird.