June 2022
Entry posted by Quinten in SEiGHT
1,008 views
June 18th, 2022
Spend: £54.04
For a while I was planning to replace my rear lights with something homebrew as I just can not find a nice aftermarket set that I like as much as I did on my previous Westfield. Having already replaced my fog and reverse lights with those from the LED AutoLamps 82 Series, I thought maybe I should do the same for the indicators and stop/tail lights...?
The old units are quite wide, and these round lights are slightly taller than the space available, so out came Fusion360 and with a mockup of the rear arch part, I designed a holder for them that covers the old fixing holes and follows the arches.
After a few iterations and trial fits, the ultimate design was printed using ToughPLA.
4 captive nuts are embedded in the print so they are screwed on and easily replaced if they are damaged, or if I'm bored with the current design 
I've had to replace the indicator relay as the current load is now too low for the original relay.
June 19th, 2022
Spend: £0.00
Enjoyed Father's Day with my son at the Bicester Scramble.
Last month: £ 3261.38
This month: £ 54.04
----------+
Total: £ 3315.42
-
1
1 Comment
Recommended Comments