Jump to content
Store Testing In Progress ×

Nosbod's Mega S2000 Blog

A blog by Nosbod in General

  • entries
    3
  • comments
    8
  • views
    21,929

About this blog

Build Diary of my Mega S2000

Entries in this blog

Set off on the wrong foot ....

Slow going today, realised that I have set off on the wrong foot with my build (following a printed manual i got when i collected my kit from Ian which I assume is now out of date) suggests to fit all the panels first. Here is the culprit ......... I only realised this today at work when i stumbled across a downloaded .pdf of the S2000 specific manual which I forgot I had acquired from someone's dropbox well before i ordered my kit . I don't think it's a major problem (fingers crossed), ju
Nosbod

Nosbod

1

More Panel Work....

Got a little it more panel work done today.. Rivetted up the passenger side tunnel panel Also got the rear bulkhead panel drilled off and fitted. I had to omit a couple of the awkward holes located in tight corners as I don't have a 90 degree head for the drill in the garage at home - they will live to see another day !! (Not sure my arms and shoulders could take any more drilling and rivet pulling today anyhoo !!!!) Began the hunt for the engine today, also chased up the next set of par
Nosbod

Nosbod

3

And so it begins .......

Greetings!! Today is a good day, it's the day I finally get my finger out and start work on my Mega S2000 build! The starter kit has been sat in my garage since 10th April. I have been waiting for some shortages which finally arrived and I didn't want to start it until I had all the bits. Progress was pretty slow and all i achieved was drilling off the tunnel side panels and fitting one of them. I hope to keep momentum going and I will endeavour to keep this blog current with the build
Nosbod

Nosbod

4
×
×
  • Create New...

Important Information

Please review our Terms of Use, Guidelines and Privacy Policy. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.