Jump to content

***SOLD SEiW 2.0 Zetec - 185BHP


mr_mcp

Recommended Posts

After much deliberation, I've made the decision to sell my fantastic Westfield after 6 years of cherished ownership. I'm planning to undertake an Ultima build, so sadly this must go.

 

Full spec listed below:

 

ENGINE & DRIVETRAIN

2.0 litre Ford Zetec engine (new piston rings fitted <4k ago)

Twin Weber carbs with a pipercross sausage filter (recently serviced)

Fully ported head (recently skimmed and valves etc fully serviced, at great expense!)

Balanced crank

Kent Cams FZ2002 Sports camshafts

Dunnell lightweight flywheel

Dunnell lowline baffled sump

High efficiency radiator

ASH silicon hoses throughout

Alloy catch can

Malpassi Competition Filter King Fuel Pressure Regulator, Gauge & Filter

Heat wrapped 4:1 exhaust manifold 

Wunoff re-packable exhaust filled with acoustafill (95dB) 

Dyno tested at 185bhp and 156 lbs/ft torque at the back wheels (Pulls hard from virtually any revs)

RS2000 alloy bellhousing

BGH Geartech E7 Pro road & track Type 9 close ratio gearbox - Ratios: 2.66, 1.75, 1.26, 1.0, 0.84 

Quaife ATB limited slip diff (lifetime warranty)

New half shaft UJs recently fitted

 

RUNNING GEAR

Wilwood Dynalite 4 pot calipers and uprated discs and pads on the front (fluid recently changed)

Standard drums at the rear (lightweight compared to discs and very effective on such a light car)

Genuine magnesium alloy 13" Minilite wheels

Toyo R888 tyres (GG compound). 205/60/13 at the rear and 185/60/13 on the front.

Adjustable Spax coilovers

Nylon suspension bushes

Bespoke rose jointed front upper wishbones

Full suspension geometry setup and corner weighted - brilliant on both road and track.

Weighs only 580Kg dry with full wet weather gear, so less with the aero screen setup and no heater etc.

 

INTERIOR

JK Composites seats with 5 piece padding set
and red piping

4 point harnesses

Carbon effect panels on the rear bulkhead and transmission tunnel

Aerodynamix carbon fibre dash

Brown & Geeson (official MOMO) quick release steering boss 

Sparco suade steering wheel

Starcom intercom

12V power socket

 

EXTERIOR
Aerodynamix carbon fibre aeroscreen (which retains the same fixings used for the full screen. Makes for easy switching between screen setups should you wish)

Carbon-NV rear diffuser with added strakes

Carbon-NV ducted CSR style cycle wings

Full LED rear light units with carbon effect housings

Carbon effect boot lid

Carbon effect wheel arch protectors 

Carbon effect centre and wing mirrors

Carbon effect nosecone canards

Carbon effect LED front indicators

MSA approved LED rear rain light

RAC roll bar

Quick release nosecone fixings

Bodywork in great condition for age. Minor repair carried out on drivers side rear arch where the previous owner ran over a traffic cone (about the size of a 50 pence piece) which you can't notice unless you look closely. I have the colour matched gel coat and hardener if you wish to tidy-up further.

 

BAD BITS - as reflected in the sale price

(Very) Minor oil leak - will lose less than a teaspoon over the course of a month

Chip on the rim of the pass front alloy (can be seen in the pics - cosmetic only)

NOW RESOLVED -- Occasionally the starter motor won't engage fully. --

 

Sailed through the MOT last week, so will come with 12 months. Fully serviced with massive history and receipts.

 

Full asking price will include the following, if desired:

Full screen with pillars and integrated wing mirrors

Wipers and wiper motor

Heater and silicone hoses

Side screens

Tonneau cover

Original dash

Original front indicators 

Original rear lights

Breathable indoor car cover (some slight wear and tear)

Link to comment
Share on other sites

Wow, a lot of car for the money.  Good luck with the sale

  • Like 2
  • Thanks 1
Link to comment
Share on other sites

I’d do what we all do - convert power to crank figure and then it’s a 200bhp car :yes:

looks nice with all the right bits. 

  • Thanks 1
Link to comment
Share on other sites

Carbon-NV

 

It's a top quality item, would highly recommend

Link to comment
Share on other sites

1 hour ago, miller said:

Can anyone tell me where to get the rear diffuser from please :yes:

Just buy @mr_mcp's car, them you don't need to buy or fit one :p 

  • Thanks 1
  • Haha 2
Link to comment
Share on other sites

On 12 August 2018 at 16:39, mr_mcp said:

Carbon-NV

 

It's a top quality item, would highly recommend

Thanks :yes:

 

Link to comment
Share on other sites

Good luck with the sale, it looks a lovely car.

And please, please, please, hang on in the Boardroom and do an Ultima build thread! :d

  • Thanks 1
Link to comment
Share on other sites

  • 3 weeks later...

Thanks for the kind comments gents :yes:

I went for a drive last night... Was meant to be a quick one, but had too much fun and stayed out for 2.5hrs, I'll certainly be sad to see it go to the next lucky owner.

A couple of snaps from my outing:

IMG_20180905_194758_zpsgfy4bytb.jpg

IMG_20180905_194818_zpsyz6jmhss.jpg

Link to comment
Share on other sites

  • 1 month later...
×
×
  • Create New...

Important Information

Please review our Terms of Use, Guidelines and Privacy Policy. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.