Jump to content

Fully Mappable ECU for a V8 Engine


KugaWestie

Recommended Posts

Hi Gary, I have an MBE956E with loom and most sensors, any good?

I am using the old crank and CAM sensor but it has water temp, air temp and lambda with it. Its currently mapped for a silvertop 1.8 Zetec

Just taken it off my Westie so know it all works

Link to comment
Share on other sites

44 minutes ago, CRAIGR said:

Got an upgrade able emerald in the garage I think Gary if of any interest , few years old though 

Any more info Craig?

Link to comment
Share on other sites

Will have a look see tomorrow Gary 

Has a part loom to run a Zetec attached 

Got a mega squirt with relay board too. 

Link to comment
Share on other sites

16 minutes ago, CRAIGR said:

Will have a look see tomorrow Gary 

Has a part loom to run a Zetec attached 

Got a mega squirt with relay board too. 

Ok, let us know what you find

Link to comment
Share on other sites

On 11/22/2017 at 20:22, CRAIGR said:

Will have a look see tomorrow Gary 

Has a part loom to run a Zetec attached 

Got a mega squirt with relay board too. 

Any Luck @CRAIGR??

Link to comment
Share on other sites

I think I have a couple of MBE 998 and new looms kicking around. Probably needs sensors. Let me take a look or chase me at acw@ggr.net

Link to comment
Share on other sites

32 minutes ago, ACW said:

I think I have a couple of MBE 998 and new looms kicking around. Probably needs sensors. Let me take a look or chase me at acw@ggr.net

Thanks

I meant to say, I need the ecu to run a Rover V8 engine, will this do that?

Link to comment
Share on other sites

×
×
  • Create New...

Important Information

Please review our Terms of Use, Guidelines and Privacy Policy. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.