Waterpump Conversion to EWP - Tonights Job
Entry posted by ACW
1,591 views
So tonight to wind down after work I decided to tackle the conversion of the water pump on the duratec engine to a water inlet from the electric water pump.
So to start off with I took the water pump off the engine and stripped off the O-ring. Using an angry grinder cut off the impeller and pulley mounting off the pump.
once this is don't the pump body can be put into the lathe and the front face lathed down to within an inch of its life. Once this is complete the shaft and bearing can be stripped out and the centre hole lathed out with a boring tool to 32mm. Now a piece of 32mm aluminium pipe is fitted through whats left of the water pump.
To fit it all together and make it water tight I then tig welded up the back of the pipe to the casting and then finished it back off with the lathe. Finally re-fit the O ring.
Finished result:
not a bad evenings work.
Edit to add: you can also get away with machining the centre to a tight fit for the flared pipe and just using Loctite 648 bearing seal rather than tig welding.
-
1
2 Comments
Recommended Comments